Cisco Nexus 5600 Series - Page 364

360
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter I Commands
ip pim ssm policy
ip pim ssm policy
To configure group ranges for Source Specific Multicast (SSM) using a route-map policy, use the ip pim
ssm policy command. To remove the SSM group range policy, use the no form of this command.
ip pim ssm policy policy-name
no ip pim ssm policy policy-name
Syntax Description
Command Default The SSM range is 232.0.0.0/8.
Command Modes Global configuration mode
VRF configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to configure a group range for SSM:
switch(config)# ip pim ssm policy my_ssm_policy
This example shows how to reset the group range to the default:
switch(config)# no ip pim ssm policy my_ssm_policy
Related Commands
policy-name Route-map policy name that defines the group prefixes where this feature is applied.
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
show ip pim
group-range
Displays information about PIM group ranges.