R Commands
restart pim
MCR-406
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
restart pim
To restart the IPv4 Protocol Independent Multicast (PIM) process, use the restart pim command.
restart pim
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to restart the PIM process:
switch(config)# restart pim
Related Commands
Release Modification
6.0(2)N1(1) This command was introduced.
Command Description
ip pim flush-routes Enables flushing routes when the PIM process is restarted.
To Next Page
Loading...
