Cisco Nexus 5600 Series - show ipv6 pim rp

451
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Chapter Show Commands
show ipv6 pim oif-list
show ipv6 pim oif-list
To display information about IPv6 Protocol Independent Multicast (PIM6) interfaces for a group, use the
show ipv6 pim oif-list command.
show ipv6 pim oif-list group [source] [vrf {vrf-name | all}]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the Enterprise Services license.
Examples This example shows how to display PIM6 interfaces for a group:
switch(config)# show ipv6 pim oif-list ff1e::0002
PIM6 OIF-List for VRF default
(*, ff1e::0002/128)
Incoming interface: Ethernet2/2, RPF nbr 0002::0002
Timeout interval: 45 secs left
Oif-list (count: 2):
Ethernet8/11, uptime: 00:01:18, pim6
Ethernet8/11, uptime: 00:01:18, pim6
Timeout-list (count: 0):
Immediate-list (count: 0):
Immediate-timeout-list (count: 0):
switch(config)#
group Group address.
source (Optional) Source address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
Release Modification
5.0(3)N1(1) This command was introduced.