Cisco Nexus 5600 Series - Page 48

Show Commands
show ip igmp snooping groups
MCR-44
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip igmp snooping groups
To display information about the group membership for IGMP snooping, use the show ip igmp snooping
groups command.
show ip igmp snooping groups [{source [group]} | {group [source]}] [vlan vlan-id] [detail]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the group membership for IGMP snooping:
switch(config)# show ip igmp snooping groups
TType: S - Static, D - Dynamic, R - Router port
Vlan Group Address Ver Type Port list
20 */* - R Vlan20
switch(config)#
source (Optional) Source address for route.
group (Optional) Group address for route.
vlan vlan-id (Optional) Specifies a VLAN. The range is from 1 to 3967 and 4048 to 4093.
detail (Optional) Displays detailed information for the group.
Release Modification
5.0(3)N1(1) This command was introduced.
4.1(2) Arguments source and group were added.