Cisco Nexus 5600 Series - Page 49

Show Commands
show ip igmp snooping mrouter
MCR-45
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip igmp snooping mrouter
To display the multicast routers detected by IGMP snooping, use the show ip igmp snooping mrouter
command.
show ip igmp snooping mrouter [vlan vlan-id]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the multicast routers detected by IGMP snooping:
switch(config)# show ip igmp snooping mrouter
Type: S - Static, D - Dynamic, V - vPC Peer Link
Type: S - Static, D - Dynamic, V - vPC Peer Link, I - Internal
Vlan Router-port Type Uptime Expires
20 Vlan20 I 04:16:16 never (down)
switch(config)#
vlan vlan-id (Optional) Specifies a VLAN. The range is from 1 to 3967 and 4048 to 4093.
Release Modification
5.0(3)N1(1) This command was introduced.
4.1(3) Changed output to include vPC information.