Cisco Nexus 5600 Series - Page 76

Show Commands
show ip pim interface
MCR-72
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim interface
To display information about the enabled interfaces for IPv4 Protocol Independent Multicast (PIM), use
the show ip pim interface command.
show ip pim interface [brief] [vrf {vrf-name | all | default | management}]
show ip pim interface ethernet {slot/port | port-channel channel-number[.sub_if-number] |
vethernet veth-id | vlan vlan-id}
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
brief (Optional) Specifies a brief format for display.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies all VRFs.
default Specifies the default VRF.
management Specifies the management VRF.
ethernet
slot/port
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
port-channel
number
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
sub_if-number (Optional) Subinterface number. The range is from 1 to 4093.
vethernet
veth-id
Specifies the virtual Ethernet interface. The range is from 1 to 1,048,575.
vlan vlan-id Specifies the VLAN. The range is from 1 to 4094.
Release Modification
5.0(3)N1(1) This command was introduced.
5.0(2) Information on Bidirectional Forwarding Detection (BFD) was added.