Show Commands
show ip pim interface
MCR-73
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
Examples This example shows how to display brief information about IPv4 PIM-enabled interfaces:
switch# show ip pim interface brief
PIM Interface Status for VRF "default"
Interface IP Address PIM DR Address Neighbor Border
Count Interface
Vlan100 192.0.2.252 192.0.2.252 0 no
port-channel2000 192.0.2.1 192.0.2.1 1 no
port-channel2001 192.0.2.8 192.0.2.8 1 no
Ethernet1/26 192.0.2.2 192.0.2.2 1 no
Ethernet2/5 192.0.2.3 192.0.2.3 1 no
Ethernet2/6 192.0.2.4 192.0.2.4 1 no
Ethernet2/7 192.0.2.5 192.0.2.5 1 no
Ethernet3/11 192.0.2.6 192.0.2.6 1 no
Ethernet3/12 192.0.2.7 192.0.2.7 1 no
switch#
This example shows how to display information about PIM-enabled interfaces:
switch# show ip pim interface ethernet 2/5
PIM Interface Status for VRF "default"
Ethernet2/5, Interface status: protocol-up/link-up/admin-up
IP address: 192.0.2.3, IP subnet: 192.0.2.0/24
PIM DR: 192.0.2.3, DR's priority: 1
PIM neighbor count: 1
PIM hello interval: 30 secs, next hello sent in: 00:00:20
PIM neighbor holdtime: 105 secs
PIM configured DR priority: 1
PIM border interface: no
PIM GenID sent in Hellos: 0x36a7d6d1
PIM Hello MD5-AH Authentication: disabled
PIM Neighbor policy: none configured
PIM Join-Prune inbound policy: none configured
PIM Join-Prune outbound policy: none configured
PIM BFD enabled: no
PIM Interface Statistics, last reset: never
General (sent/received):
Hellos: 454/453, JPs: 4/0, Asserts: 0/0
Grafts: 0/0, Graft-Acks: 0/0
DF-Offers: 0/0, DF-Winners: 0/0, DF-Backoffs: 0/0, DF-Passes: 0/0
Errors:
Checksum errors: 0, Invalid packet types/DF subtypes: 0/0
Authentication failed: 0
Packet length errors: 0, Bad version packets: 0, Packets from self: 0
Packets from non-neighbors: 0
JPs received on RPF-interface: 0
(*,G) Joins received with no/wrong RP: 0/0
(*,G)/(S,G) JPs received for SSM/Bidir groups: 0/0
JPs filtered by inbound policy: 0
JPs filtered by outbound policy: 0
switch#
To Next Page
Loading...
