Cisco Nexus 5600 Series - Page 78

Show Commands
show ip pim neighbor
MCR-74
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim neighbor
To display information about IPv4 Protocol Independent Multicast (PIM) neighbors, use the show ip
pim neighbor command.
show ip pim neighbor {[ethernet slot/port | port-channel channel-number[.sub_if-number] |
vethernet veth-id | vlan vlan-id] | [neighbor-addr]} [vrf {vrf-name | all | default |
management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
ethernet
slot/port
(Optional) Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
port-channel
number
(Optional) Specifies the EtherChannel interface and EtherChannel number. The
range is from 1 to 4096.
sub_if-number (Optional) Subinterface number. The range is from 1 to 4093.
vethernet
veth-id
(Optional) Specifies the virtual Ethernet interface. The range is from 1 to 1,048,575.
vlan vlan-id Specifies the VLAN. The range is from 1 to 4094.
neighbor-addr (Optional) IP address of a neighbor.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies that all VRF entries be cleared from the IPv4 multicast routing table.
default Specifies that the default VRF entry be cleared from the IPv4 multicast routing table.
management Specifies that the management VRF entry be cleared from the IPv4 multicast routing
table.
Release Modification
5.0(3)N1(1) This command was introduced.
5.0(2) Information on Bidirectional Forwarding Detection (BFD) was added.