Cisco Nexus 5600 Series - show ip pim route

Show Commands
show ip pim route
MCR-83
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
OL-31626-01
show ip pim route
To display information about the routes for IPv4 Protocol Independent Multicast (PIM), use the show ip
pim route command.
show ip pim route {source group | group [source]} [vrf {vrf-name | all | default | management}]
Syntax Description
Command Default None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to display IPv4 PIM routes:
switch(config)# show ip pim route 232.0.0.0
PIM Routing Table for VRF "default" - 1 entries
(*, 232.0.0.0/8), expires 00:02:15
Incoming interface: Null0, RPF nbr 0.0.0.0
Oif-list: (0) 00000000, timeout-list: (0) 00000000
Immediate-list: (0) 00000000, timeout-list: (0) 00000000
Timeout-interval: 3, JP-holdtime round-up: 3
source Source address.
group Group address.
vrf (Optional) Applies to a virtual routing and forwarding (VRF) instance.
vrf-name VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
all Specifies that all VRF entries be cleared from the IPv4 multicast routing table.
default Specifies that the default VRF entry be cleared from the IPv4 multicast routing table.
management Specifies that the management VRF entry be cleared from the IPv4 multicast routing
table.
Release Modification
5.0(3)N1(1) This command was introduced.