Cisco PenTeleData 8800 Series - Page 8

!"#$%&'(&()%*+&,,--&.+/"+#&0#+/&12"3+
8 | Page
Add a Bluetooth Headset
Procedure
Step 1 Make your Bluetooth headset discoverable.
Step 2 Press Applications .
Step 3 Select Bluetooth > Devices
Step 4 Select Scan.
Step 5 Select your headset and press Connect.
Step 6 (Optional) If prompted, enter the PIN for your headset.
Disconnect a Bluetooth Headset
You should disconnect your Bluetooth headset before you use it with another device.
Procedure
Step 1 Press Applications .
Step 2 Select Bluetooth > Devices.
Step 3 Select a Bluetooth headset.
Step 4 Press Disconnect.
Remove a Bluetooth Headset
Remove your Bluetooth headset if you aren't going to use it with your phone again.
Procedure
Step 1 Press Applications .
Step 2 Select Bluetooth > Devices.
Step 3 Select a Bluetooth headset and press Delete.
Enable Voice Feedback from Accessibility
You can enable or disable the Voice Feedback feature by pushing the Select button on the Navigation ring three times.
But you can also access this feature from the Accessibility setting on your phone.
With Voice Feedback enabled, you press your Softkey buttons twice to use or configure a feature.