Cisco IP Phone 8800 Series

To Next Page

●

Move Audio from a Cisco IP Phone 8800

Series Multiplatform Phone to Mobile Device

and Vice Versa

Objective

The Cisco IP Phone 8800 Series Multiplatform Phones allow you to pair your mobile device

such as phone or tablet through Bluetooth. This connection allows you to make and answer

phone calls on either the mobile device or the IP Phone. This ability to use the mobile line on

your IP phone is called Intelligent Proximity.

Note: To learn how to configure a mobile device on your IP Phone, click here.

After configuring your mobile device, your IP phone displays an additional phone line with

your mobile phone number. You can then make, receive, and move calls from your mobile

phone through your IP Phone.

If you have both a Bluetooth headset and a mobile device connected, you cannot use the

Bluetooth headset to answer the audio from the mobile device.

This article provides instructions on how to manage mobile calls on your Cisco IP Phone

8800 Series Multiplatform Phone.

Applicable Devices

8800 Series

Software Version

11.0.1 — 8851, 8861

Manage Audio from the IP Phone to Mobile and Vice Versa

After pairing your mobile device with your IP Phone, you can use either the IP Phone or your

mobile phone to answer or receive calls on your mobile line. You can also move or swap the

audio while on an active call. The IP Phone supports connections from Android and iOS

tablets and phones.

Move the Audio of an Active Call through your IP Phone

Step 1. Answer an incoming mobile call on your IP Phone by pressing the Answer softkey.

Otherwise, press the Decline softkey.

Note: Available options may vary according to the exact model of your device. In this

example, an iPhone6s mobile phone is configured with Cisco 8851 IP Phone.

Need help?

Do you have a question about the Cisco IP Phone 8800 Series and is the answer not in the manual?

Cisco IP Phone 8800 Series Specifications

General