CHAPTER
1-1
Cisco PIX Firewall Hardware Installation Guide
78-15170-01
1
Preparing for Installation
This chapter describes how to install and add PIX Firewall hardware upgrades that accompany the unit.
The information in this guide applies to the PIX 501, PIX 506E, PIX 515/515E, PIX 520, PIX 525, and
PIX 535. In this guide, the term “PIX Firewall” refers to all models unless specifically noted otherwise.
Caution Installing a PIX Firewall Version 6.0(1) or higher, such as a PIX Firewall “Classic,” PIX10000, or
PIX 510 on an older unit, causes a continuous reboot until a version previous to 6.0(1) is reinstalled.
This chapter includes the following sections:
• Installation Overview, page 1-1
• Safety Recommendations, page 1-2
• General Site Requirements, page 1-4
Installation Overview
Complete these steps to prepare for the installation of a PIX Firewall:
Note If your PIX Firewall model supports a failover configuration, perform the steps that follow only on the
primary (active) unit. (Not applicable to the PIX 501 or the PIX 506E.)
Step 1 Review the safety precautions outlined in the Regulatory Compliance and Safety Information for the
Cisco PIX Firewall document.
Step 2 Completely read the release notes for your respective software version.
Step 3 Unpack the PIX Firewall. The PIX Firewall consists of two main components, the PIX Firewall unit and
a separate accessory kit. The accessory kit contains documentation, a power supply or cord, rack
mounting hardware (not applicable to the PIX 501 or the PIX 506E), and additional software you can
use with your PIX Firewall.
Step 4 Place the PIX Firewall on a stable work surface.
To Next Page
Loading...
Need help?
General
