EasyManuals Logo
Home>Cisco>Network Hardware>PIX Series

Cisco PIX Series Hardware Installation Guide

Cisco PIX Series
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
6-5
Cisco PIX Firewall Hardware Installation Guide
78-15170-01
Chapter 6 PIX 525
PIX 525 Feature Licenses
Step 6 Connect the network cables to the expansion interface ports. (The inside, outside, or perimeter network
connections can be made to any available interface port on the PIX 525.) The first expansion port
number, at the top left, is interface 2. Starting from that port and going from left to right and top to
bottom, the next port is interface 3, the next is interface 4, and so on. Refer to PIX 525 Feature
Licenses for information on how to configure the ports.
Step 7 If you have a second PIX Firewall to use as a failover unit, install the failover feature and cable as
described in Installing Failover.
Note Do not power on the standby failover unit until the primary unit is configured.
Step 8 When you are ready to start the PIX 525, power on the unit from the switch at the rear of the unit.
PIX 525 Feature Licenses
If you have the PIX-525-UR unrestricted feature license, the following options are available:
If you have a second PIX 525 to use as a failover unit, install the failover feature and cable as
described in Installing Failover.
If needed, install the PIX Firewall Syslog Server as described on the logging command page in the
Cisco PIX Firewall Command Reference.
If you need to install an optional circuit board, refer to Installing a Circuit Board in the PIX 525.
If you need to install additional memory, refer to Installing a Memory Upgrade.
Note If, for any reason, you may choose to downgrade to any software version, note that you must use the
clear flashfs command before doing so. A new section is added to Flash memory that must be cleared
before downgrading.
For information on upgrading feature licenses or downloading the latest software versions, go to the
following website:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/config/upgrade.htm
This section includes the following topics:
PIX Firewall VPN Accelerator Card, page 6-6
PIX Firewall VPN Accelerator Card+, page 6-6

Table of Contents

Other manuals for Cisco PIX Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco PIX Series and is the answer not in the manual?

Cisco PIX Series Specifications

General IconGeneral
BrandCisco
ModelPIX Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals