Cisco Secure Network Server 3700 Series User Manual

Installing the Cable Management Arm (Optional)
The cable management arm (CMA) is reversible left-to-right. To reverse the CMA, see Reversing the Cable
Management Arm (Optional), on page 23 before installation.
Note
Step 1 With the appliance pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the appliance onto
the end of the stationary slide rail that is attached to the rack post. Slide the tab over the end of the rail until it clicks and
locks.
Figure 10: Attaching the CMA to the Rear Ends of the Slide Rails
CMA tab on width-adjustment slider
attaches to end of stationary outer slide rail.
3CMA tab on arm farthest from appliance
attaches to end of stationary outer slide
rail.
1
Rear of appliance4CMA tab on arm closest to the appliance
attaches to end of inner slide rail attached
to appliance.
2
Step 2 Slide the CMA tab that is closest to the appliance over the end of the inner rail that is attached to the appliance. Slide the
tab over the end of the rail until it clicks and locks
Step 3 Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the width of your
rack.
Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide
22
Installing the Appliance
Installing the Cable Management Arm (Optional)

Cisco Secure Network Server 3700 Series Specifications

General

Brand	Cisco
Model	Secure Network Server 3700 Series
Category	Network Hardware
Language	English