4-17
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
OL-13478-03
Chapter 4 Installing the Internet Streamer CDS Software and Initially Configuring a CDE
Verifying the CDSM
Step 3 From the CDSM Main menu, select the Devices tab. A list of all your registered Service Engines and
Service Routers appears (see
Figure 4-20).
Figure 4-20 Devices Page
Step 4 Verify that the devices you configured for your CDS network are listed.
Step 5 If a device is not listed, restart the CMS for that device by using either the console or Telnet connection
and entering the following commands in global configuration mode:
CDE(config)# no cms enable
CDE(config)# cms enable
The installation is now complete. Refer to the Cisco Internet Streamer CDS 2.0-2.1 Software
Configuration Guide for information on configuring and using the CDS. See the
“Related
Documentation” section on page 2-viii.
To Next Page
Loading...
Need help?
General
