Need help?Do you have a question about the Cisco SF300-24P and is the answer not in the manual?
General| Switching Capacity | 12.8 Gbps |
|---|---|
| Forwarding Rate | 9.52 Mpps |
| PoE Budget | 180W |
| Layer | Layer 2 |
| Dimensions | 440 x 257 x 44 mm |
| MAC Address Table Size | 8K entries |
| Uplink Ports | 2 x combo Gigabit SFP |
| Jumbo Frame Support | 9216 bytes |
| VLANs | 255 |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -20°C to 70°C (-4 to 158°F) |
| Relative Humidity | 10% to 90%, non-condensing |
| Standards Compliance | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab |
| Management | Managed |
Detailed steps for installing the switch into a standard 19-inch rack.
Instructions for wall-mounting the 8-port Cisco 300 Series switches.
Information on PoE capabilities and compatibility with powered devices.
Overview of accessing the switch via web interface or console port for configuration.
Step-by-step guide for configuring the switch using a console port connection.
Common connection issues and their solutions, including network and IP address problems.
Description of the RJ-45 Ethernet and SFP ports on the front panel.
Explanation of the status lights (LEDs) on the front panel of the switch.
Identification of power and console ports located on the back panel.
Resources for obtaining technical support and community assistance.
Links to additional documentation, compliance, and warranty information.
To Next Page
