Cisco SG 200-08 User Manual

200 Series 8-Port Smart Switches 3
Wall Mounting
NOTE The switch should be mounted so that the ports face up or down.
Do not mount the switch with the ports to the side, as this causes strain
on the connections.
There is a wall-mount kit packed with your switch. The dimensions for the
mount kit are as follows:
Mount the smart switch to the wall by drilling two pilot holes 95 mm (3.7
inches) apart, attaching the provided anchors and screws to the wall, then
sliding the switch into position on the screws.
The switch must have a minimum of 5 inches (130 mm) of clearance on all
sides.
WARNING Insecure mounting might damage the device or cause injury.
Cisco is not responsible for damages incurred by insecure wall-
mounting.
1 0.4 in/8 mm 2 0.9 in/22.2 mm 3 0.3 in/6.8 mm 4 0.7 in/17.6 mm
1
2
4
3
196243

Cisco SG 200-08 Specifications

General

Model	SG 200-08
Ports	8 x 10/100/1000
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps
Layer	Layer 2
Management	Web-based
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% non-condensing
MAC Address Table Size	8K entries
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-4 to 158°F (-20 to 70°C)
Storage Humidity	10% to 95% non-condensing