Getting Started
Starting the Web-based Switch Configuration Utility
Cisco Small Business 300 Series Managed Switch Administration Guide 3
1
Password Expiration
The New Password Page is displayed:
• The first time you access the switch with the default username cisco and
password cisco. This page forces you to replace the factory default
password.
• When the password expires, this page forces you to select a new
password.
Logging Out
By default, the application logs out after ten minutes of inactivity. You can change
this default value as described in the Defining Idle Session Timeout section in the
General Administrative Information and Operations chapter.
CAUTION Unless the Running Configuration is copied to the Startup Configuration, all
changes made since the last time the file was saved are lost if the switch is
rebooted. We recommend that you save the Running Configuration to the Startup
Configuration before logging off to preserve any changes you made during this
session.
A red X icon displayed to the left of the Save application link indicates that Running
Configuration changes have been made that have not yet been saved to the Startup
Configuration file.
When you click Save, the Copy/Save Configuration Page is displayed. Save the
Running Configuration file by copying it to the Startup Configuration file. After this
save, the red X icon and the Save application link are no longer displayed.
To logout, click Logout in the top right corner of any page. The system logs out of
the switch.
When a timeout occurs or you intentionally log out of the system, a message is
displayed and the
Login Page
opens, with a message indicating the logged-out
state. After you log in, the application returns to the initial page.
The initial page displayed depends on the “Do not show this page on startup”
option in the Getting Started Page. If you did not select this option, the initial page
is the Getting Started Page. If you did select this option, the initial page is the
System Summary Page.
To Next Page
Loading...
