Cisco SPA100 Series Administration Guide

Configuring the Voice Settings
Regional
Cisco SPA100Series Administration Guide 79
4
Speed Dial Act
Code
Assigns a speed dial number.
Default setting: *74
Paging Code Used for paging other clients in the group.
Default setting: *96
Secure All Call Act
Code
Makes all outbound calls secure.
Default setting: *16
Secure No Call Act
Code
Makes all outbound calls not secure.
Default setting: *17
Secure One Call
Act Code
Makes the next outbound call secure. (It is redundant if all
outbound calls are secure by default.)
Default setting: *18
Secure One Call
Deact Code
Makes the next outbound call not secure. (It is redundant if
all outbound calls are not secure by default.)
Default setting: *19
Conference Act
Code
If this code is specified, the user must enter it before
dialing the third party for a conference call. Enter the code
for a conference call.
Default setting: blank
Attn-Xfer Act Code If the code is specified, the user must enter it before
dialing the third party for a call transfer. Enter the code for
a call transfer.
Default setting: blank
Modem Line
Toggle Code
Toggles the line to a modem. Modem passthrough mode
can be triggered only by pre-dialing this code.
Default setting: *99
FAX Line Toggle
Code
Toggles the line to a fax machine.
Default setting: #99
Media Loopback
Code
Use for media loopback.
Default setting: *03
Field Description

Cisco SPA100 Series Specifications

General

Brand	Cisco
Model	SPA100 Series
Category	Adapter
Language	English