Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 140
6
<Feature_Dial_Services_Code>s These codes tell the ATA what to do when the user is listening
to the first or second dial tone.
One or more *codes can be configured into this parameter,
such as *72, or *72|*74|*67|*82, etc. The maximum length is 79
characters. This parameter applies when the user has a dial
tone (first or second dial tone) After receiving dial tone, a user
enters the *code and the target number according to current
dial plan. For example, after user dials *72, the ATA plays a
special tone called a Prompt tone while awaiting the user to
enter a valid target number. When a complete number is
entered, the ATA sends a INVITE to *72 target_number as in a
normal call. This feature allows the proxy to process features
like call forward (*72) or Block Caller ID (*67)
The *codes should not conflict with any of the other vertical
service codes internally processed by the ATA. You can
remove a corresponding *code that you do not want to the
ATA to process.
You can add a parameter to indicate which tone plays after
the *code is entered, such as *72‘c‘|*67‘p‘. Below is a list of
allowed tone parameters (note the use of open quotes
surrounding the parameter, without spaces)
‘c‘ = <Cfwd Dial Tone>
‘d‘ = <Dial Tone>
‘m‘ = <MWI Dial Tone>
‘o‘ = <Outside Dial Tone>
‘p‘ = <Prompt Dial Tone>
‘s‘ = <Second Dial Tone>
‘x‘ = No tones are place, x is any digit not used above
If no tone parameter is specified, the ATA plays Prompt tone
by default. If the *code is not to be followed by a phone
number, such as *73 to cancel call forwarding, do not include
this parameter. Instead, add the *code in the dial plan and the
ATA send INVITE *73@..... as usual when user dials *73.
Default setting: blank
<Service_Annc_Base_Number> Base number for service announcements.
Default setting: blank
To Next Page
Loading...
Need help?
General