Cisco SPA500DS User Manual

Cisco SPA500DS 7
STEP 8 Locate the AUX OUT port on the back of the first Cisco SPA500DS.
Connect one end of the auxiliary cable to this port.
STEP 9 Locate the AUX IN port on the back of the second Cisco
SPA500DS. Connect the other end of the auxiliary cable to this
port.
STEP10 Route the auxiliary cable inside the cable slot. The Cisco
SPA500DS is powered by the auxiliary cable with the Cisco
SPA500 Series IP Phone; no additional power source is required.
STEP11 Attach the appropriate desktop stands to each unit.
Configuring the Cisco SPA500DS
You can configure the Cisco SPA500DS buttons for speed dials, line
monitoring, one-touch transfer, and other features (if supported by your
phone system). Configuration instructions depend on the phone system
with which you are using the Cisco SPA500DS.
To configure the Cisco SPA500DS for use with a Cisco SPA9000 Voice
System or other SIP telephony system (such as a Broadsoft or Asterisk
system), see the Cisco Small Business SPA300 Series, SPA500 Series,
and WIP310 Administration Guide on Cisco.com. For other telephony
systems, see the documentation for that product.

Cisco SPA500DS Specifications

General

Brand	Cisco
Model	SPA500DS
Category	Telephone Accessories
Language	English