Cisco TelePresence DX70 User Manual

17
D1510413 User Guide
Cisco TelePresence DX70, DX80
Produced: April 2016 for CE8.2
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.
Your video system network may
be equipped with the capability to
initiate a video conference with
several participants.
The maximum number of participants
supported by your video system will
depend on system conguration and
the video infrastructure. If in doubt,
contact your video support team.
If you want to initiate a video
conference, you must call each
participant one by one.
If you are the one who initiated
the conference you will be able to
terminate the entire conference.
The other participants may only
disconnect themselves from the
conference.
Call settings. Those you call may
have video systems with dierent
bandwidths. You are not constrained
to set all participants to a bandwidth
that all systems support. The Call
rate may be set individually for all
participants in order to provide
everyone with the best quality
available for their system. See
“Change Call Rate” on page 14.
Conference Calls with Multiple Participants
Add Additional Participants to Existing Call
This is an optional feature that may, or may not, be available for your system.
About Video Conferences
Locate whom to call, in the
usual way.
Assume that you already are in
a call. This call may have been
initiated by you or by someone
else (someone called you). Tap
Add.
Place the call, in the usual way.
You may alter the Call settings
of that call before you place
it—see side bar for more.
This new call will now be
added to the existing.
You have now established a
conference.
You may repeat this procedure
to the extent permitted by your
video infrastructure.

Cisco TelePresence DX70 Specifications

General

Brand	Cisco
Model	TelePresence DX70
Category	Conference System
Language	English