Cisco TelePresence MX200 G2 Installation Guide

13
Organize pre-mounted cables
78-100574-02A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Installation guide for Cisco TelePresence MX800 Dual - Floor stand
Page 18
Left
monitor
Right
monitor
To the left of camera module
On the right side of monitor
In center
Power (step 16)
Ethernet (step 16)
Loudspeaker cables
4 - 5 (step 17)
2 ×
Loudspeaker cables
2 - 6 (step 17).
Cable 1 is not used
HDMI (step 14)
HDMI (step 16)
USB, type B (step 14)
Power over Ethernet
(step 14)
Loudspeaker cable 6
(s tep 17)
HDMI (step 16)
To the right of camera module
5 ×
Stretch out the cables in the channel on top of the monitors,
and place them as illustrated. Do not unplug any cables.
The camera module is connected in step 15 and the cables
are connected in steps 14, 16 and 17.

Cisco TelePresence MX200 G2 Specifications

General

Resolution	1920 x 1080
Network	10/100/1000 Ethernet
Product Type	Video conferencing system
Display Size	42 in
Camera	PrecisionHD 1080p Camera
Codec	Cisco TelePresence Codec
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI
Control	Cisco Touch 10
Video Standards	H.264
Connectivity	HDMI
Codec Support	H.264
Resolution (fps)	1080p30