EasyManuals Logo
Home>Cisco>Server>UCS C220

Cisco UCS C220 Installation And Service Guide

Cisco UCS C220
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
3-37
Cisco UCS C220 Server Installation and Service Guide
OL-25760-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
g. Replace the server in the rack, replace cables, and then power on the server by pressing the Power
button.
h. If the card that you replaced was a RAID controller, continue with Restoring RAID Configuration
After Replacing a RAID Controller, page C-23.
Special Considerations for Cisco UCS Virtual Interface Cards
Table 3-8 describes the requirements for the supported Cisco UCS virtual interface cards (VICs).
Special Considerations for Cisco UCS Fusion ioDrive2 Storage Accelerator Cards
Table 3-9 describes the requirements for the supported Cisco UCS Fusion ioDrive2 cards.
Ta b l e 3-8 Cisco UCS C220 Requirements for Virtual Interface Cards
Virtual Interface
Card (VIC)
Number of
VICs
S
upported
in
Server
Slots That
Support
VICs
1
1. See PCIe Slots, page 3-35.
Primary Slot For
UCS Integration
or Cisco Card
NIC Mode
Minimum
CIMC
Firmware
Minimum VIC
Firmware For
Use With UCS
Integration
Minimum Nexus
OS on an Upstream
Nexus Fabric
Interconnect
Cisco UCS VIC P81E
N2XX-ACPCI01
1 PCIE 1 PCIE 1 1.4(4) 2.0(2) 5.0
Cisco UCS VIC 1225
UCSC-PCIE-CSC-02
1 PCIE 1 PCIE 1 1.4(6) 2.1(0) 5.0
Cisco UCS VIC1225T
UCSC-PCIE-C10T-02
1 PCIE 1 PCIE 1
2
2. The Cisco UCS VIC1225T is not supported for UCS integration at this time.
1.5(1) 2.1(1) 5.0
Ta b l e 3-9 Cisco UCS C220 Requirements for Fusion ioDrive2 Cards
Card
Max. Number of
Cards Supported
Slots That
Su
pport Cards
1
1. See PCIe Slots, page 3-35.
Minimum CIMC
Firmware
Card Height
(rear-panel tab)
Cisco UCS 3.0 TB MLC Fusion ioDrive2
UCSC-F-FIO-3000M
1 PCIE 1 1.5(2) Full height
Cisco UCS 1205 GB MLC Fusion ioDrive2
UCSC-F-FIO-1205M
2 PCIE 1
PCIE 2
2
2. Slot 2 is not available in single-CPU configurations.
1.5(2) Half height
3
3. A rear-panel tab adapter is required to fit the half-height cards in full-height slot 1.
Cisco UCS 785 GB MLC Fusion ioDrive2
UCSC-F-FIO-785M
2 PCIE 1
PCIE 2
1.5(2) Half height
Cisco UCS 365 GB MLC Fusion ioDrive2
UCSC-F-FIO-365M
2 PCIE 1
PCIE 2
1.5(2) Half height

Table of Contents

Other manuals for Cisco UCS C220

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS C220 and is the answer not in the manual?

Cisco UCS C220 Specifications

General IconGeneral
BrandCisco
ModelUCS C220
CategoryServer
LanguageEnglish

Related product manuals