© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 4 of 7
●
Power-saving sleep mode and port control features help maximize energy efficiency.
●
Highly secure guest access enables safe wireless connectivity for visitors.
●
Support for IPv6 lets you deploy future networking applications and operating systems without
costly upgrades.
Specifications
Table 1 lists the specifications, package contents, and minimum requirements for the Cisco WAP121 Wireless-N
Access Point with Single Point Setup.
Table 1. Specifications
Specifications Description
Standards IEEE 802.11n, 802.11g, 802.11b, 802.3af, 802.3u, 802.1X (security authentication), 802.1Q (VLAN), 802.1D
(Spanning Tree), 802.11i (WPA2 security), 802.11e (wireless QoS), IPv4 (RFC 791), IPv6 (RFC 2460)
Ports LAN Fast Ethernet auto sensing, DC jack
Switch Power button (on/off)
Buttons Power (on/off) push button, Reset button
Cabling type Category 5e or better
Antennas Internal antennas optimized for wall, ceiling, or desktop placement
LEDs Power, WLAN, LAN
Operating system Linux
Physical Interfaces
Ports 10BASE-T/100BASE-TX Ethernet, 12V DC power with support for 802.3af PoE
Power supply External 12V 0.5A DC power jack (Energy Star 2.0 compliant with Efficiency Level 5) and 802.3af PoE
Buttons Power (on/off) push button; Reset button
Lock slot Slot for Kensington lock
LED Power, Wireless, Ethernet
Physical Specifications
Physical dimensions (W x D x H) 4.89 x 4.89 1.38 in. (124.17 x 124.17 x 35 mm)
Weight 0.37 lb or 168 g
PoE
PoE 802.3af
Peak PoE power 6W
Network Capabilities
VLAN support Yes
Number of VLANs 1 management VLAN plus 4 VLANs for Service Set ID (SSID)
Multiple SSIDs 4
802.1X supplicant Yes
SSID to VLAN mapping Yes
Auto channel selection Yes
Spanning tree Yes
Load balancing Yes
IPv6 Yes
●
IPv6 host support
●
IPv6 RADIUS, syslog, Network Time Protocol (NTP), etc.
Layer 2 802.1Q-based VLANS, 4 active VLANS plus 1 management VLAN
To Next Page
Loading...
