© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 5 of 8
Specifications Description
Spanning tree Yes
Load balancing Yes
IPv6 Yes
●
IPv6 host support
●
IPv6 RADIUS, syslog, Network Time Protocol (NTP), etc.
Layer 2 802.1Q-based VLANS, 8 active VLANS plus 1 management VLAN
Security
WEP/WPA/WPA2 Yes, including Enterprise authentication
Access control Yes, management access control list (ACL) plus MAC ACL
Secure management HTTPS
Wi-Fi Protected Setup (WPS) Yes (soft WPS, no hardware push button)
SSID broadcast Yes
Rogue access point detection Yes
Mounting and Physical Security
Multiple mounting options Desktop installation; mounting bracket included for easy ceiling or wall mounting
Physical security lock Kensington lock slot
Quality of Service
Quality of service (QoS) Wi-Fi Multimedia Traffic Specification (WMM TSPEC)
Performance
Wireless throughput Data rate =300 Mbps; actual client throughput will vary.
Recommended user support Up to 32 connective users, 20 active users
Configuration
Web user interface Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)
Multi-Access Point Management
Single Point Setup Yes
Maximum access points per
cluster
8
Active clients per cluster 80
Management
Management protocols Web browser, SNMP v3, Bonjour
Remote management Yes
Event logging Local, remote syslog, email alerts
Network diagnostics Logging and packet capture
Web firmware upgrade Firmware upgradable through web browser, imported/exported configuration file
Dynamic Host Configuration
Protocol (DHCP)
DHCP client
IPv6 host Yes
HTTP redirect Yes, and captive portal
Wireless
Frequency Selectable-band 2.4 GHz or 5 GHz (not concurrent)
Radio and modulation type Single radio, orthogonal frequency division multiplexing (OFDM)
WLAN 802.11n
Operating channels 1 to 13 (depending on country)
Wireless isolation Wireless isolation between clients
External antennas None