Page 10
3.3 MAINTENANCE SCHEDULE
FREQUENCY
INSPECT
REPLACE
Before and after each use
Every 50 hours
All screw nuts, bolts correctly
tighten, silent-block in, and
check carburation.
Belt transmission
Clean air filter
Transmission belt
Every 100 hours
Cylinder head decarbonizing
Diameter of clutch and clutch
bell
Bearing crankshaft
Glass wool
Silencer
Spark plug
Every 200 hours Oil seal crankshaft
Piston complete
Cooling belt
Every 500 hours Thermical group .
Connecting rod
Crankshaft bearing
Each year All rubber and plastic
components.
Fuel diaphragm carburettor ,
spark plug.