Page 6
1.3 RUNNING-IN PROCEDURE
Following proper break-in procedure helps censure that some of the most important and
expensive components on your new C-Max will provide maximum performance and service
life. (Also follow proper run-in procedure for a newly rebuilt engine)
1. Do not hold the throttle in one position for more than a few seconds. It’s better
to roll the throttle on and off, without getting too high altitudes and forcing the
engine.
2. Use the motor for features of 10 minutes at a time and to leave to cool it.
3. After 5 hours of use or approximately 20 litres of gasoline the motor should be
broken in.
4. This same procedure should be followed each time
• Piston is replaced
• Cylinder is replaced
• Crankshaft or crank bearings are replaced
To Next Page
Loading...
Need help?
General
