Ciscomotors C-Max User Manual

Page 9
3. MAINTENANCE
3.1 GENERAL SERVICE INFORMATION:
• Wear gloves and glances when you make the maintenance;
• Do not perform maintenance while engine is running. Injury to your fingers, hands or head
may result ;
• Perform maintenance on firm, level ground, using hard work plain , and not directly on
chassis;
• Always install new gaskets, o-rings, piston pin clips, rings etc .when reassemble some
parts.
• When tightening bolts, nuts or screw, start with the larger diameter or inner fasteners, and
tighten them to the specified torque using a criss-cross pattern;
• Use genuine Ciscomotors parts when maintenance your C
CC
C-
--
-Max
MaxMax
Max
• Clean parts in not-flammable cleaning solvent when disassembling. Lubricate any sliding
surface, o-rings and seals before reassembling.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
Gasoline or low flash point solvents are highly flammable or explosive and must never be
used for cleaning parts . Fire or explosion could result.
• After reassembling, check all parts for proper installation and operation
NOTE:
• Specification are listed chapter 2.
3.2 ROUTINE CLEANING
• If the C
CC
C-
--
-Max
MaxMax
Max is only little dirty to clean up it with clean dusts cloth without solvents
• If the C
CC
C-
--
-Max
MaxMax
Max is much dirty to clean up it with biodegradable detergents and not with
solvents, lubricate where is necessary.
Engine Number
Figure B

Ciscomotors C-Max Specifications

General

Brand	Ciscomotors
Model	C-Max
Category	Engine
Language	English