39
Additional feature
<Water Sensing Function>
This watch is provided with a water sensor. Whenever this sensor senses traces of water
in any other mode display, the watch automatically enters the diving mode with [Ready
display].
* During the chronograph measurement, however, the mode change is disabled.
When
the moisture is removed, the watch is released from the [Ready display]
state.
[0 m Reading after Depth Measurement]
DIV mark turns on
• A depth of 0.0 m flashes.
• Diving time is displayed.
While button A is pressed, the maximum depth and minimum
temperature reached in this dive are indicated.
3.If button M is pressed for 2 seconds or longer with the display of [0 m (0 ft) Reading after
Depth Measurement], then the watch returns to the time/calendar mode.
* If the display of [0 m (0 ft) Reading after Depth Measurement] is allowed to stand for 10
minutes or longer, the watch automatically enters the time/calendar mode.
If the diver dives again deeper than 1 m (4 ft) within 10 minutes, the dive time counting
resumes.
Button M
Button A
Time/Calendar
Mode
38
I. DIVING MODE
When in any other mode, the watch will enter the diving mode with the display changing to
[Ready display] by pressing button M for 2 seconds or more. If [Ready display] put in this
way is allowed to stand for about 60 minutes, the display automatically returns to the preced-
ing mode.
One of the following three displays is shown in the diving mode.
[Ready display] [Depth Measurement Readings]
• DIV mark flashes. • DIV mark flashes.
Display before mode change • Diving depth is indicated.
• Diving time is displayed.
When button M is pressed for 2 seconds While button A is pressed, the maximum depth
or more, the watch returns to the time/ and water temperature are indicated.
calendar mode.
1.When a depth of 1 m (4 ft) is reached after you begin diving with the watch displaying
[Ready display], the display will automatically change to [Depth Measurement Readings].
2.When the diving depth becomes less than 1 m (4 ft), the display will automatically change
to [0 m (0 ft) Reading after Depth Measurement].
Button M
Button A
To Next Page
Loading...
