Citizen CH-617 - C. Taking a Blood Pressure Measurement; D. Storing and Managing Measurement Data

16
*Note!
Do not inflate the cuff until it is wrapped around your wrist.
on the display and then the air pressure will automatically
pump up to 195 mmHg. If blood pressure tends to be on the
high level, the air pressure will automatically increase to the
required level for measurement.
D. Storing, recalling and erasing measurement data:
a. Storing data:
After each blood pressure measurement, the Systolic blood
pressure, diastolic blood pressure, pulse and the time & date
of specic day will be automatically stored. The memory
holds the latest 99 measurement data. If more than 99
measurements, the memory will automatically clear out the
earliest data.
e. After taking blood pressure measurement, the Systolic blood
pressure, Diastolic blood pressure and pulse will be on the
display for 1 minute.
*Note!
• If the cuff does not stop inating, remove the cuff at once.
• To interrupt the measurement, you may press the
button.
The cuff will deate immediately after a button is pressed.
* Do not move or talk in the midst of taking blood pressure
measurement.
d. After the air pressure is increased, it will slowly decrease.
When the pulse is detected,
will start ashing.