Citizen E812 - Using the Chronograph; Using the Local Time; Displaying the Local Time; Setting the Time Difference

2/3
E812 Abbreviated instruction
Using the chronograph
• Measuring up to 60 minutes in 1/20 second increments.
• The hour, minute and 24-hour hands move normally during chronograph
measurement.
1.
Push the crown in to position
0
.
2.
Rotate the crown to change the mode to [CHR].
The chronograph second hand moves to 0 second and the chronograph
minute hand moves to 0 minute and they stop.
Start/stop: press button
A
.
• The chronograph minute hand indicates the 1/20 second units by pressing
and holding button
B
while chronograph is stopped. Release the button to
return the hand to minute indication.
Reset: press button
A
while the chronograph is stopped.
• Be sure to reset chronograph after finishing measurement.
Using the local time
When the mode is changed to [L-TM], the time for another region separate from
the current time (local time) is displayed.
• The time difference can be set up to ±23 hours (in 1 hour units) based on the
time set in [TME] mode.
• The minute and second hands show the same time as that in [TME].
Displaying the local time
1.
Push the crown in to position
0
.
2.
Rotate the crown to change the mode to [L-TM].
Local time is indicated.
Setting the time difference
1.
Pull the crown out to position
2
when the mode hand points [L-
TM].
2.
Rotate the crown to set the time difference.
• Rotate the crown counterclockwise when the time difference to set is minus.
Rotate the crown clockwise when the time difference to set is plus.
• If the hour hand passes the midnight during the setting, the date indication
will be advanced by 1 day. It takes some time to complete the date indication
to be advanced.
3.
Push the crown in to position
0
to finish the procedure.
Using the alarm
1.
Push the crown in to position
0
.
2.
Rotate the crown to change the mode to [ALM].
Hour, minute and 24-hour hands indicate the current alarm time setting and
the second hand indicates the current alarm setting (“ON” or “OFF”).
3.
Pull the crown out to position
2
.
The alarm setting is automatically turned to “ON”.
4.
Rotate the crown to set the alarm time.
• Check AM/PM of the alarm time referring to the 24-hour hand.
• When you rotate the crown quickly, the hands will move continuously. To
stop the rapid movement, rotate the crown.
• The alarm time cannot be set based on the local time.
5.
Push the crown in to position
0
to finish the procedure.
To set the alarm ON/OFF
While in the [ALM] mode, pull the crown out to position
1
or
2
and press
button
A
.
To stop alarm
Press button
A
or
B
.
The alarm sounds for 15 seconds.
To check the alarm sound
Press and hold button
A
in the [ALM] mode while the crown is in the position
0
.
The alarm tone can be monitored.