1/3
E812 Abbreviated instruction
• This watch is solar-powered. Expose the dial to light and use it sufficiently charged.
• To see details of charging time, specifications and operations, refer to the instruction manual:
E812 instruction manual
English
Component identification
Minute hand
Date indication
Crown
Button
A
Button
B
Function hand/
Chronograph minute hand
Hour hand
24-hour hand
Alarm indication (ON/
OFF)
Mode hand
Second hand/
Chronograph second hand
Crown's position
0 1 2
• Actual appearance may differ from the illustration.
• The crown has two positions when pulling it out.
Changing the mode
This watch features four different modes: [TME] (time/calendar), [CHR]
(chronograph/reference position correction), [L-TM] (local time), and [ALM]
(alarm).
1.
Push the crown in to position
0
.
2.
Rotate the crown.
The mode hand moves and the mode is changed.
Setting the time
1.
Push the crown in to position
0
.
2.
Rotate the crown to change the mode to [TME].
3.
Pull the crown out to position
2
.
The second hand stops at 0 second.
4.
Rotate the crown to set the time.
• Check AM/PM of the time referring to the 24-hour hand.
• When you rotate the crown quickly, the hand will move continuously. To
stop the rapid movement, rotate the crown.
5.
Push the crown in to position
0
in accordance with a reliable
time source to finish the procedure.
The second hand starts moving.
Setting the calendar
1.
Push the crown in to position
0
.
2.
Rotate the crown to change the mode to [TME].
3.
Pull the crown out to position
1
.
The current setting of the year and mouth is indicated.
Function hand: year since leap year
Second hand: month
4.
Rotate the crown counterclockwise to set the date indication.
• When you rotate the crown quickly, the date indication will move
continuously. To stop the rapid movement, rotate the crown.
• The date indication changes to the first day of the next month after finishing
setting if you set a non-existing day.
5.
Press and release the upper right button
A
and lower right
button
B
repeatedly to adjust the year and the month.
• Button
A
changes the year setting indicated by the function hand.
• Button
B
changes the month setting indicated by the second hand.
Month indication
“Month” corresponds to one of the 12
markers in the figure below.
Each number means month.
Year indication
“Year” corresponds to the years since
leap year and is indicated with markers
in the figure below.
Each number means year since leap
year.
6.
Push the crown in to position
0
to finish the procedure.
The second hand moves to indicate the current second.
To Next Page
Need help?
General
