The year corresponds to the years since leap year and is indicated with the position of the second hand.
5. Repeat steps 3 and 4.
6. Push the crown in to position in accordance with a reliable time source.
The second hand starts moving from 0 second.
7. Change the mode to [TME] to finish the procedure.
Checking the reference position
1. Change the mode to [CHR] and pull the crown out to position .
The second and function hands and dual time indication point to 0 position and stop.
2. Press and hold the lower right button A.
The hands and indication start to move to the current reference positions stored in memory.
• Release the button as the hands start to move.
3. Check the reference position.
Correct reference positions:
• Hour, minute and second hands: 0 hour 00 minute 0 second
• Date indication: midway between “31” and “1”
• Function hand: “0.0” (straight above)
• Dual time indication: 0 hour 00 minute
When the current reference position is different from the correct one, proceed to step 3 of “Correcting the reference position”.
4. Push the crown in to position .
5. Change the mode to [TME] to finish the procedure.
Correcting the reference position
1. Change the mode to [CHR] and pull the crown out to position .
The second and function hands and dual time indication point to 0 position and stop.
2. Press and hold the lower right button .
The hands and indication start to move to the current reference positions stored in memory.
• Release the button as the hands start to move.
3. Press and release the lower right button .
The function hand slightly moves and the hand and date indication become adjustable.
4. Press and release the lower right button repeatedly to change the hand/indication to be corrected.
• Each time you press the button, the target changes as follows: Function hand/date indication Dual time indication Hour and minute hands Second hand (Back to the
top)
• The hands slightly move when selected to show they become adjustable.
5. Rotate the crown to adjust the hand/indication.
• When you rotate the crown quickly a few times, the hand/indication will move continuously. To stop the rapid movement, rotate the crown in either direction.
6. Repeat steps 4 and 5.
7. Push the crown in to position .
To Next Page
Loading...
