Citizen H11A Abbreviated Instruction

2/2
H11A/H110/H111/H113/H119 Abbreviated instruction
Setting the time difference
You can indicate time in a different time zone without adjusting time by setting
time difference.
• You can set time difference in 1-hour increments in the range of ±27 hours.
1.
Push the crown in to position
0
.
2.
Press and release the upper right button
B
.
The second hand shows the time difference currently set.
3.
Rotate the crown to set the time difference.
• The hour hand moves 1 hour as the second hand moves 1 step.
±0
–5
+5
–10
+10
–27 +27
4.
Press and release the upper right button
B
to finish the
procedure.
• It returns to current time indication automatically in about 10 seconds
without pressing the button.
Checking the reference position
1.
Push the crown in to position
0
.
2.
Press and hold the upper right button
B
for 5 seconds or more.
The hands and indication start to move to the current reference positions
stored in memory.
3.
Check the reference position.
Correct reference positions:
• Hour, minute and second hands: 0 hour 00 minute 0 second
• Date indication: “1”
When the current reference position is different from the correct one, adjust
the position following the steps of
Correcting the reference position
.
4.
Press and release the upper right button
B
to finish the
procedure.
Correcting the reference position
1.
Push the crown in to position
0
.
2.
Press and hold the upper right button
B
for 5 seconds or more.
The hands and indication start to move to the current reference positions
stored in memory.
• Release the button as the hands/indication start to move.
3.
Pull the crown out to position
2
and wait until all the hands
and indication stop.
4.
Press and release the lower right button
A
repeatedly to
change the hand/indication to be corrected.
• Each time you press the button, the target changes as follows:
Date indication → hour hand → minute/second hands → (back to the top)
5.
Rotate the crown to adjust the hand/indication.
• When you rotate the crown quickly a few times, the hand/indication will
move continuously. To stop the rapid movement, rotate the crown in either
direction.
• The minute and second hands move synchronously.
6.
Repeat steps 4 and 5.
7.
Push the crown in to position
0
.
8.
Press and release the upper right button
B
to finish the
procedure.
After correcting the reference position
After correctiong the reference position, adjust the time and calendar manually or
by receiving time signals manually (on-demand reception).

Citizen H11A Specifications

General

Brand	Citizen
Model	H11A
Category	Watch
Language	English