CITIZEN 26/38
7-2 Dip-Switch (DS-2) Setting
(only for Serial Interface)
No. Functions ON OFF Factory
Setting
1 to chose
Word's Length 7 bit 8 bit OFF
2 Parity Checking No Yes ON
3 Parity Checking Even Odd OFF
4 Baud rate - see the table below - OFF
5 Setting ON
6 On-Line Mode *1 DC3 DC3 OFF
LF code DESELECT code
7 - not used - OFF
8 - not used - OFF
Baud rate Selection
No. 1200 2400 4800 9600
4 OFF ON OFF ON
5 OFF OFF ON ON
*1
Your iDP3535 Dot Matrix Printer (Serial Interface model only) has been upgraded to provide you with
a new feature is called ‘OLMODE’ or ON - Line Mode. In this mode, the SEL (select) switch on
the operator panel is not used and the printer is always in the ‘SEL’ (selected) or ON – Line Mode.
Also, the LF (linefeed) switch on the operator panel will function while the printer is this mode,
even when the printer is in the ‘SEL’ (selected) Mode.
This feature is activated by placing the Dip Switch DS-2, Number 6 in the ‘ON’ position.
To Next Page
Loading...
