- Eng 13 -
English
TIME ADJUSTMENT
Setting the clock enables measurements to be accurately recorded.
The monitor can record the date and time of measurement as well as the
measurement results. Be sure to set the clock after inserting the batteries. Set the
date fi rst and then the time.
1 Press and hold the Date/Time Set switch for approximately two
seconds.
The “year” indicator blinks.
2 Press the Adjust switch to adjust the year.
Press
Adjust switch to increase the number by one.
(The year can be adjusted in the range of 2011-2040.)
Press
Date/Time Set switch to confi rm the setting.
The “year” is set and the “month” indicator blinks.
3 Press the Adjust switch to adjust the “month”.
Press Adjust switch to increase the number by one.
Press
Date/Time Set switch to confi rm the setting.
The “month” is set and the “day” indicator blinks.
4 Press the Adjust switch to adjust the “day”.
Press Adjust switch to increase the number by one.
Press
Date/Time Set switch to confi rm the setting.
The “day” is set and the “hour” indicator blinks.
* You can fast-forward the numbers in display by
pressing and holding
Adjust switch.
* When you install the batteries for the fi rst time, the monitor will display the
clock setting screen. You do not need to perform step 1. Proceed to step 2.
If you set the clock and change its setting, start from step 1.
To Next Page
Loading...
