E-18
Delete error
(Ex.6) : If you enter and delete a value that isn’t included in the stored
data by mistake, “dEL Error ” appears, but the previous data are still
retained, for example, delete 7 based on Ex.1.
Step 1 : Press 7 [ 2ndF ] [ DEL ]
DEG STAT
dEL Error
Step 2 : Press any key to clear it
DEG STAT
0.00
Step 3 : Enter ED mode, then view data by [ DATA ] or [ = ],
where those data are still data 1 = 2.00, data 2~5 = 5.
00, data 6~8 = 9.00.
(Ex.7) : Based on Ex.1, enter 5 x 5 and delete it.
Step 1 : Press 5 [ x ] 5 [ 2ndF ] [ DEL ]
DEG STAT
dEL Error
Step 2 : Press any key to clear it
DEG STAT
0.00
Step 3 : Enter ED mode, then view data by [ DATA ] or [ = ],
where those data are changed as data 1 = 2.00, data
2~4 = 9.00.
Weighted data entry method
Instead of entering directly each data, when often several item of data
have the same value, you can enter the value and the number of occur-
rences up to 255. The data based on Ex.1 can be rewritten and entered as
follow :
Value Number of occurrences Alternative method
21 [ DATA ] 2
5 4 [ DATA ] 5 [ x ] 4
9 3 [ DATA ] 9 [ x ] 3
, where data 1 = 2, data 2~5 = 5, data 6~8 = 9.
Under ED mode, when you continue choosing a value from data 2~5 and
correcting it as 33, the permutation among those data will be changed as
data 1 = 2, data 2~4 = 5, data 5 = 33, data 6~8 = 9, where the new value 33
is inserted after data 4 = 5.
(Note) : A “FULL” is indicated when any of the following conditions occur
and further data entry becomes impossible. Just pressing any
key can clear the indicator. The previous data entries are still
retained unless exiting STAT mode.
1) If the times of data entry by [ DATA ] is more than 80
2) The number of occurrences is more than 255
3) n
20400 (n = 20400 appears when the times of data entry by
[ DATA ] are up to 80 and the number of occurrences for each
value are all 255, i.e. 20400 = 80 x 255.)
To Previous Page
Loading...
