8
153
In the event of a breakdown
When removing the lamp unit:
F
with tailgate, pull the lamp unit towards the
centre of the vehicle,
F with side-hinged doors, pull the lamp unit
towards you.
F Remove the two fixing bolts using the
spanner provided.
F Pull the lamp unit from the outside.
F
While holding the lamp, disconnect the
electrical connector.
F
Move aside the 4 tabs, then extract the bulb
holder.
F
Remove the faulty bulb by pressing it lightly
while turning it anti-clockwise.
F Change the bulb.
When refitting, take care to reposition
the tabs and the wiring correctly to avoid
trapping the wiring.
After changing a rear direction indicator
bulb, the reinitialisation time is more than
approximately 2
minutes.
Number plate lamps
Type A, W5W – 5W
With tailgate
F Remove the plastic lens using a
screwdriver.
F Change the bulb.
F
Refit the plastic lens and press on it.
With side-hinged doors
F Unclip the interior trim.
F
Disconnect the connector by moving aside
its tab.
F Turn the bulb holder a quarter turn
anticlockwise.
F
Change the bulb.
F Put the bulb holder back in place and
reconnect the connector.
F Put the trim back in place.
https://www.automotive-manuals.net/
To Next Page
Loading...
