CITROEN C 3 2020 - Spare Wheel

117
In the event of a breakdown
8
► Check that the compressor switch is in
position "O".
► Fully uncoil the electric cable stowed under
the compressor.
► Connect the compressor's electric plug to the
vehicle's 12 V socket.
► Switch on the ignition.
The tyre ination pressures are given on
this label.
► Start the compressor by placing the switch at
position "I" and adjust the pressure to the value
shown on the vehicle's tyre pressure label. To
deate: press the black button located on the
compressor pipe, near the valve connection.
If after 7 minutes the pressure of 2 bar is
not reached, the tyre is damaged;
contact a CITROËN dealer or a qualied
workshop for assistance.
► Once the correct pressure is reached, put the
switch in position "O".
► Remove the kit and stow it.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-ination detection system.
For more information on Tyre under-ination
detection, refer to the corresponding section.
Spare wheel
Access to the spare wheel
The spare wheel is installed in the boot, under
the oor.
Depending on engine, the spare wheel is
a standard wheel or the space-saver type
(BlueHDi).
Removing the spare wheel
► Unclip the tool storage box (standard spare
wheel).
► Slacken the central nut.
► Remove the fastening device (nut and bolt).
► Lift the spare wheel towards you from the
rear.
► Take the wheel out of the boot.
If there is no wheel in the well, the
fastening device (nut and bolt) cannot be
retted.
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does
not obstruct tra󰀩c: the ground must be level,
stable and non-slippery.
With a manual gearbox, engage rst gear
to lock the wheels, apply the parking brake,