119
In the event of a breakdown
8
► Remove the bolts and store them in a clean
place.
► Remove the wheel.
Stowing the damaged wheel
► To stow an alloy wheel, rst remove
the wheel trim from the centre of the wheel so
that the fastening device (nut and bolt) can be
put in place.
► In the case of a "space saver" type
spare wheel, the damaged wheel cannot be
stowed under the oor. It must be placed in
the boot; use a cover to protect the inside of
the boot.
Fitting a wheel
Fitting a steel or ‘space-saver’ type
spare wheel
If the vehicle is equipped with alloy wheels,
the washers do not make contact with the
steel or ‘space-saver’ type spare wheel. The
wheel is secured by the conical surface of
each bolt.
► Fit the wheel on the hub.
► Screw in the bolts by hand as far as possible.
► Pre-tighten the bolts using the wheelbrace
5 only.
► Lower the vehicle again fully.
► Fold jack 6 and remove it.
► Tighten the bolts using the wheelbrace 5 only.
► Ret the bolt covers to each of the bolts
(depending on equipment).
► Store the tools.
To Next Page
Loading...
