CITROEN C 3 2020 - Page 19

17
Instruments
1
Starting prevented
Whenever the ignition is switched on, the
"Emissions fault: Starting prevented" or "NO
START IN" message is displayed.
To be able to restart the engine, contact
a CITROËN dealer or a qualied
workshop.
Total distance recorder
The total distance recorder measures the total
distance travelled by the vehicle since its initial
registration.
With the ignition on, the total distance is
displayed at all times. It remains displayed for
30 seconds after switching o󰀨 the ignition. It is
displayed when the driver's door is opened, and
when the vehicle is locked or unlocked.
When travelling abroad, you may have to
change the distance units (km or miles):
the road speed must be displayed in the local
country’s o󰀩cial unit (km/h or mph).
The unit is changed via the screen
conguration menu, with the vehicle
stationary.
Total distance recorder
It measures the total distance travelled by the
vehicle since its rst registration.
Trip distance recorder
This measures the distance travelled since it was
last reset by the driver.
Resetting the trip recorder
► With the ignition on, press the button until
dashes appear.
Equipment conguration
for vehicles without
screen
If your vehicle does not have an audio system
or a touch screen, you can still congure some
equipment by using the LCD text instrument
panel display.
Control buttons
A long press of this button takes you to
the conguration menu, a short press
conrms.
Pressing one of these buttons lets
you move in a menu, a list; change
a value.
Pressing this button takes you back up a
level or cancels the current operation.
Display screen menus
LIGHTING
– DAYTIME LAMPS,
– AUTO HEADLAMPS (Automatic headlamp
dipping),
– GUIDE LAMPS (Guide-me-home lighting),
– WELCOME LAMPS (Welcome lighting).
DRIVE ASSIST
– TYRE PRESSURES (Reinitialisation of the
under-ination detection system),
– VIGILANCE ALT (Driver attention detection),
– ADVISED SPEED (Speed limit recognition),
– COLLISION ALT (Collision risk alert),