65
Safety
5
“ISOFIX" mountings
The seats shown below are tted with ISOFIX
compliant mountings:
The mountings comprise three rings for each
seat, indicated by a marking:
– Two rings A, located between the vehicle seat
backrest and cushion.
The 2 latches of ISOFIX child seats are secured
to them.
– One ring B, located behind the seat, called
the TOP TETHER, for xing seats tted with an
upper strap.
* Depending on country of sale.
This system prevents the child seat from tipping
forward in the event of a front impact.
This ISOFIX mounting system provides fast,
reliable and safe tting of the child seat in the
vehicle.
To secure the child seat to the TOP TETHER:
► Remove and stow the head restraint before
installing the child seat on this seat (ret it once
the child seat has been removed).
► Route the strap of the child seat behind the
seat backrest, in-between the 2 head restraint
anchor points.
► Secure the upper strap hook to ring B.
► Tighten the upper strap.
When tting an ISOFIX child seat to the
left-hand rear seat of the bench seat,
before tting the seat, rst move the centre
rear seat belt towards the middle of the
vehicle, so as to avoid the seat interfering
with the operation of the seat belt.
An incorrectly installed child seat
compromises the child's safety in the
event of an accident.
Strictly observe the tting instructions
provided in the user guide supplied with the
child seat.
For information about the options for
tting ISOFIX child seats in your vehicle,
refer to the summary table.
Recommended ISOFIX child
seats
Also consult the user guide from the child
seat’s manufacturer to nd out how to
install and remove the seat.
"RÖMER Baby-Safe Plus and its ISOFIX
base"
(size category: E)
Group 0+: from birth to 13 kg
To Next Page
Loading...
