EasyManua.ls Logo

CITROEN C 3 2020 - Page 75

CITROEN C 3 2020
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
73
Driving
6
audible signal, to remind you that the key is
still in the ignition switch at position 1 (Stop).
If the key has been left in the ignition switch
at position 2 (Ignition on), the ignition will be
switched o󰀨 automatically after one hour.
To switch the ignition back on, turn the key
to position 1 (Stop), then back to position 2
(Ignition on).
Starting / Switching o󰀨 the
engine with Keyless Entry
and Starting
The electronic key must be present in the
passenger compartment.
If it is not detected, a message is displayed.
Move the electronic key so that the engine
can be started or switched o󰀨.
If there is still a problem, refer to the "Key
not detected - Back-up starting or Back-up
switch-o󰀨" section.
Starting
With a manual gearbox, place the gear lever
in neutral and fully depress the clutch pedal.
With an automatic gearbox, select mode P
or N and press the brake pedal.
Press the "START/STOP" button while
maintaining pressure on the pedal until the
engine starts.
For Diesel engines, when the temperature is
below zero and/or the engine is cold, starting will
only occur once the preheating warning lamp is
o󰀨.
If this warning lamp comes on after
pressing the "START/STOP" button:
Keep the pedal fully depressed and do not
press the "START/STOP" button again until the
engine is running.
If one of the starting conditions is not met, a
message is displayed.
In some circumstances, a message indicates
that it is necessary to turn the steering wheel
while pressing the "START/STOP" button to
assist unlocking of the steering column.
With petrol engines, after a cold start,
preheating the catalytic converter can
cause noticeable engine vibrations for
anything up to 2 minutes while stationary with
the engine running (accelerated idle speed).
Switching o󰀨
Immobilise the vehicle, with the engine at
idle.
With a manual gearbox, ideally put the gear
lever into neutral.
With an automatic gearbox, ideally select
mode P or N.
Press the "START/STOP" button..
In some circumstances, it is necessary to turn
the steering wheel to lock the steering column.
If the vehicle is not immobilised, the
engine will not switch o󰀨.
With the engine o󰀨, the braking and
steering assistance systems are also cut
o󰀨 - risk of loss of control of the vehicle!
Never leave your vehicle with the
electronic key still inside.

Related product manuals