COMFORT
Fully-folded position Flaps behind the rear seats
Move the corresponding front seat
forward if necessary.
Place the head restraints in the low
position.
Pull control A , to release the seat
back which folds easily onto the
seat cushion.
This manoeuvre automatically re-
tracts the seat cushion.
The seat fi ts into the fl oor, providing a
continuous level fl oor.
To put the seat back in position:
Pull the seat back backwards until it
locks in place.
Return the seat cushion to the de-
sired position.
Flaps B fi tted to the back of the rear
seat close the boot fl oor when the rear
seats are in the forward position.
Pull on the upper section of the fl aps to
release them.
They then provide a continuous level
fl oor.
Adjusting the head restraints
The 1/3 - 2/3 rear seat is fi tted with head
restraints.
They have a high position (for comfort
and safety) and a low position (for rear
visibility).
They may be removed, as follows:
pull the head restraint upwards as
far as possible,
then, press on the lug A .
When you are carrying rear pas-
sengers, never drive with the head
restraints removed. They must be
secured in place in the high position.
When putting back in position,
take care not to jam the seat
belts.
Ensure that they are correctly fi xed
to the seat back before any ma-
noeuvre.
Each fl ap is fi xed to the rear of
the seat by two removable plastic
clips.
To detach the fl aps from the rear
of the seat back, press fi rmly down
on the upper part of the two plastic
clips to release them.
To avoid risk of breakage, they dis-
engage if subjected to excessive
force.
To Next Page
Loading...
