84
ENGINE
AUXILIARY EQUIPMENT DRIVE BELT for «STOP AND START»
Engine: KFU
Tools.
[1] Compression tool : 4388-T
[2] Pliers for removing plastic pins : 7504-T
IMPERATIVE: Respect the precautions to be taken prior to any operation.
Removing-refitting the «stop and start» accessories belt.
Raise and support the vehicle, front wheels hanging.
Disconnect the battery.
Remove the front RH wheel and the front RH splash-shield, using tool [2].
Position tool [1] on the tensioner (1).
Compress the tensioner (1).
IMPERATIVE: The tensioner (1) must be compressed slowly. The spanner should take
10 seconds for one rotation.
Remove the accessories drive belt.
Refitting.
Refit the accessories drive belt.
Keep to the following sequence: crankshaft pinion, aircon compressor pulley, reversible alternator pulley and
tensioner roller.
Release the tensioner, using tool [1].
IMPERATIVE: Never release the tensioner only. Use the tool [1] to decompress.
Remove the tool [1].
Refit the front RH splash-shield and the front RH wheel.
Return the vehicle to the ground and reconnect the battery.
ESSENTIAL: Perform the operations that are necessary after a reconnection of the battery
(see corresponding operation)
.
B1BP3BEC
C3
B1EP1J8C
To Next Page
Loading...
