Putting the wheel back in place
) Put the box back in place in the centre of
the wheel and clip it.
) Put the polystyrene storage box back
in place.
) Refit the boot floor carpet by lightly
folding it in the middle (refer to the section
"Fittings - § Storage box").
) Put the wheel back in its housing.
) Unscrew the yellow central bolt by a
few turns then place it in the centre of
the wheel.
) Tighten fully until the central bolt clicks to
retain the wheel correctly.
On vehicles equipped with a "space-
saver" type spare wheel, the punctured
wheel can be stowed in place of the
"space-saver" wheel; however the boot
floor will not then be flat.
To Next Page
Loading...
