Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
) First of all, use the key in the lock to unlock
or lock your vehicle.
) Then, reinitialise the remote control.
If the problem persists, contact a CITROËN
dealer as soon as possible.
Remote control problem
Reinitialisation
) Switch off the ignition.
) Turn the key to position 2 (Ignition) .
) Press the closed padlock immediately
for a few seconds.
) Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR1620/3 volts.
) Unclip the casing by inserting a coin at the
notch and rotating.
) Slide the flat battery out of its location.
) Slide the new battery into its location
observing the original direction.
) Clip the casing in place, then the chrome
finisher.
) Reinitialise the remote control.
If the battery is flat, you are
informed by lighting of this warning
lamp in the instrument panel, an audible signal
and a message in the multifunction screen.
) Unfold the key.
) Release the chrome finisher by pressing
on lug A .
) Maintain pressure on lug A and remove
the chrome finisher by sliding it off at 45°.
To Next Page
Loading...
