PRACTICAL INFORMATION
Connect the compressor's elec-
tric plug to the vehicle's 12 V
socket again.
Start the vehicle again and leave
the engine running.
Adjust the pressure using the
compressor (to infl ate: switch A
in position "1" ; to defl ate:
switch A in position "0" and
press button B ), in accordance
with the vehicle's tyre pressure
label (located on the door aper-
ture on the driver's side), then re-
member to check that the leak is
plugged correctly (no further loss
of pressure after several miles
[kilometres]).
Remove the compressor, then
store the whole kit.
Drive at reduced speed (50 mph
[80 km/h]).
Visit a CITROËN dealer as soon as
possible to have the tyre repaired
or replaced by a technician.
Take care, the bottle of
sealant contains ethylene
-
glycol. This product is
harmful if swallowed and causes
irritation to the eyes. Keep it out of
reach of children.
The expiry date of the sealant is in-
dicated on the base of the bottle.
The bottle is designed for a single
use; even if only partly used, it must
be replaced.
After use, do not discard the bot-
tle into the environment, take it to a
CITROËN dealer or to an authorised
waste disposal site.
Do not forget to obtain a new
bottle of sealant, available from
CITROËN dealers.
If the vehicle is fi tted with tyre
under-infl ation detection, the tyre
under-infl ation warning light will re-
main on after the wheel has been
repaired until the system is reini-
tialised by a CITROËN dealer.
To Next Page
Loading...
