IX
149
DRIVING
Displays in the instrument panel
- The gear lever position is dis-
played in the instrument panel,
on the left on the A and C multi-
function screens and on the right
on NaviDrive and MyWay multi-
function screens.
- A back-lit position grille associ-
ated with the gear lever shows
the position selected.
When the ignition is on, il-
lumination of the service
warning lamp, accompa-
nied by an audible signal and
the message "Gearbox faulty"
indicates a malfunction.
Contact a CITROËN dealer or a
qualifi ed workshop.
For safety:
) position N can only be disen-
gaged if you are pressing the
brake pedal.
) if the gearbox is in position N
but the gear lever position is dif-
ferent, reposition the gear lever
on N in order to be able to start.
Moving off
) To start the engine, the gear le-
ver must be in position N .
) Press fi rmly on the brake pedal.
) Operate the starter.
) When the engine is running,
place the gear lever on R , A or
M as desired.
) In the instrument panel, check
the position engaged.
) Release the brake pedal and ac-
celerate.
If the gear lever is not in position N ,
and/or if the brake pedal is not
pressed, the corresponding warning
lamp(s) are displayed and a mes-
sage informs you that at least one of
these two conditions is not met.
In this case, the engine will not start,
recommence the above procedure.
6-SPEED ELECTRONIC
EARBOX SYSTEM
The 6-speed electronic gearbox of-
fers a choice between the comfort of
fully automatic operation or the driving
pleasure of manual gear changing.
You have a choice of two driving
modes:
-
automatic mode for automatic con-
trol of the gears by the gearbox,
- manual mode for sequential
changing of the gears by the
driver.
) Automated mode: gear lever 2 in
position A .
) Manual mode: gear lever 2 in po-
sition M .
In automated mode, temporary man-
ual operation is possible any time by
using one of the paddles 1 .
Mode selection
To Next Page
Loading...
